MFCMAPI Full command line switchs

Dec 19, 2012 at 4:43 AM

Hi i was going through the entire Codeplex webiste ... was looking out for the full list of Command line switches we can use in MFCMAPI for e.g.  i found one

mrmapi -mid -profile .... name

to get the message id in outlook

Dec 21, 2012 at 7:38 PM

Did you try posting in the project discussion page here?

Dec 23, 2012 at 10:52 AM

yes i did post , as i was looking out for all the command line switch for Mrmapi , please advice..





Best Regards........
Leon Thomas K.
leon_thomas@hotmail.com
" If you can Imagine it, You can do it "




From: [email removed]
To: [email removed]
Date: Fri, 21 Dec 2012 11:38:59 -0800
Subject: Re: MFCMAPI Full command line switchs [CodePlex:407251]

From: tomcornelius
Did you try posting in the project discussion page here?
Read the full discussion online.
To add a post to this discussion, reply to this email (CodePlex@discussions.codeplex.com)
To start a new discussion for this project, email CodePlex@discussions.codeplex.com
You are receiving this email because you subscribed to this discussion on CodePlex. You can unsubscribe on CodePlex.com.
Please note: Images and attachments will be removed from emails. Any posts to this discussion will also be available online at CodePlex.com